 Roof Rails
Roof rails or side rails are vehicles with factory-installed rails. These rails are flushed against the roof
or slightly raised off the roof which typically runs front to back on either side on the roof.

 Fixed Point
Some vehicles have fittings that are reinforced lugs in the roof, these are pre fitted on the roof or
they have pre-threaded screw holes that are attached with roof rails as desired depending on the
need for storage.

 Flush Rails
Flush rails run similar to the typical roof rails that run front to back on either side of the car. The roof
rails will flush to the surface of the car roof. Typically there will be no space between the rail bottom
and the car roof top.

 Rain Gutter
These are older roof racks that were typically mounted directly onto the gutter that surrounds the
roof line of the vehicle.

 Bare Roof
Bare roof means the attachments are not on the roof. Most modern vehicles, which typically do not
have gutters, can have an attachment of roof rack installed to the edge of the door frame, which
serves the purpose.

 Factory Bars
There are vehicles that have a factory-installed roof rack permanently attached to the roof.

Typical installation
(Removing carriers when not used and refitting)
You can absolutely fit the roof rack by yourself. This simple DIY job has five pointers that you need to
keep in mind while fixing and removing.
1. Although this is DIY (do it yourself). You will need a second pair of hands for ease of
installation and reduced damage/scratches on your vehicle.
2. Read the instructions – it is smart to read the instructions. It may contain essential
information especially the fitting position, the torque setting etc. So it is important to read
the instructions and follow them carefully while installing.
3. Clean your roof before beginning and keep it clean during the fitting as well. The dust or dirt
that gets trapped between the mounting points or the support system and the roof surface
may scratch the paint work off your car. Therefore, ensure the roof is clean before and
throughout the fitting.
4. Lubricate them. A small quantity of copper grease on all the bolts can ensure easy removal
of the roof. This way you can have trouble-free installation and dismantle the roof system
5. Torque settings – It is essential you get the torque setting right. Over tightening of the roof
rack can damage the car. So pay attention to the details on the instruction manual and
precisely follow them.